Double Cuff Case

Rugged case for your handcuffs, designed to be compatible with as many brands and styles of cuffs as possible!

Zero9 Standard Cuff Case for NON-ASP handcuffs, designed to fit MOST brands of standard HINGED OR CHAIN handcuffs currently on the market (see below). The standard cuff case has a retention screw to get a better fit and feel on your draw and re-holster. The oversized handcuffs (large blades - almost like leg irons for the hands) DO NOT fit these cases due to their extremely oversized blades.

The Zero9 ASP Cuff Case is designed to carry the HINGED OR CHAIN ASP cuffs in any configuration and hold them securely until needed. NOTE: DOUBLE ASP CASES EXTEND APPROXIMATELY 3.5" OFF THE DUTY BELT OR VEST. KEEP THAT IN MIND WHEN ORDERING. OUR CASES ARE AS MINIMAL AS POSSIBLE HOWEVER ASP CUFFS ARE LARGE AND THUS THE CASES FOR THEM ARE LARGER THAN STANDARD CUFFS.

* IMPORTANT INFORMATION:

SELECT MOLLE-LOKS FOR MOLLE VESTS OR TEK-LOK FOR DUTY BELTS
SMITH & WESSON CUFFS - THEY DO FIT THESE CASES BUT DEPENDING ON HOW STOUT YOU LIKE YOUR DRAW YOU MAY GET BETTER MILEAGE FROM INSERTING AND DRAWING THEM AT AN ANGLE TOWARDS THE SIDE OF THE CASE.
THE OLD VERSIONS OF PEERLESS CUFFS ARE MUCH SMALLER THAN STANDARD/MODERN CUFFS AND THEREFORE DO NOT FIT THE CASE. THESE CUFFS DO NOT HAVE THE 4 RIVETS ON THE BASE. THEY MOST OFTEN DO NOT HAVE MODEL NUMBERS OR MARKINGS ON THEM.
THE NEW ASP SENTRY CUFFS DO NOT FIT PRIOR VERSIONS OF THE ASP CUFF CASES - THEY ONLY FIT THE DEDICATED ASP SENTRY CASE.